Jeep Cherokee 2000 Service Manual - page 1774
(3) Remove the backing from the tape, align the
molding and position it on the body panel.
(4) Press the molding onto the body panel with a
roller or hand pressure.
REAR FENDER FLARE
REMOVAL
(1) Remove the screw attaching the lower part of
flare to the bottom of the fender.
(2) Remove the nuts attaching the fender flare
retainer to the wheelhouse liner (Fig. 61).
(3) Separate the fender flare and retainer from the
fender.
INSTALLATION
(1) Position the fender flare and retainer on the
fender.
(2) Install the nuts attaching the fender flare and
retainer to the wheelhouse liner.
(3) Install the screw attaching the lower part of
flare to the bottom of the fender.
QUARTER WINDOW APPLIQUE
REMOVAL
(1) Remove the liftgate pillar trim.
(2) Remove nuts from inside vehicle (Fig. 62).
(3) Using a trim sick or equivalent, carefully pry
the applique the from panel.
INSTALLATION
(1) Position the replacement applique the on panel
and install the nuts.
(2) Install the liftgate pillar trim.
DRIP RAIL MOLDING
REMOVAL
(1) Pry the clips from the roof flange.
(2) Remove the clips and molding from the roof
flange (Fig. 62).
Fig. 60 Body Side Molding—4-Door
Fig. 61 Fender Flare
1 – CENTER RETAINER
2 – WHEELHOUSE LINER
3 – BODY
4 – REAR RETAINER
5 – FENDER FLARE
Fig. 62 Quarter Window Applique and Drip Molding
1 – VEHICLE ROOF
2 – DRIP MOLDING
3 – DRIP MOLDING CLIP
4 – DRIP MOLDING
5 – CLIP
6 – QUARTER WINDOW APPLIQUE
7 – VEHICLE BODY
8 – NUT
9 – SEALANT
XJ
BODY
23 - 49
REMOVAL AND INSTALLATION (Continued)