Jeep Cherokee 2000 Service Manual - page 1475
OVERRUNNING CLUTCH/LOW-REVERSE DRUM
DISASSEMBLY
(1) If the clutch assembly came out with the low-
reverse drum, thread two clutch cam bolts into the
cam. Then lift the cam out of the drum with the bolts
(Fig. 164). Rotate the cam back and forth to ease
removal if necessary.
(2) Remove the clutch roller and spring assembly
from the overrunning clutch race.
ASSEMBLY
(1) Assemble clutch rollers and springs in retainer
if necessary (Fig. 165).
(2) Install overrunning clutch roller, spring and
retainer assembly in clutch cam (Fig. 166).
(3) Temporarily assemble and check overrunning
clutch operation as follows:
(a) Assemble cam and clutch.
Fig. 164 Removing Overrunning Clutch From
Low-Reverse Drum
1 – CAM BOLTS
2 – LOW-REVERSE DRUM
3 – OVERRUNNING CLUTCH AND CAM
Fig. 165 Overrunning Clutch Rollers, Springs,
Retainer
1 – RETAINER
2 – SPRING
3 – ROLLER
Fig. 166 Assembling Overrunning Clutch And Cam
1 – CLUTCH CAM
2 – CLUTCH ROLL ASSEMBLY
Fig. 163 Checking Input Shaft End Play
1 – TOOL 8266-8
2 – TOOL 8266-7
3 – TOOL C-3339
XJ
AUTOMATIC TRANSMISSION—30RH
21 - 175
DISASSEMBLY AND ASSEMBLY (Continued)