Jeep Cherokee 2000 Service Manual - page 1554
(10) Install speedometer adapter clamp and retain-
ing screw. Tighten clamp screw to 10-12 N·m (90-110
in. lbs.) torque.
(11) Connect wires to vehicle speed sensor.
(12) Lower vehicle and top off transmission fluid
level, if necessary.
SPEED SENSOR ROTOR-SPEEDOMETER DRIVE
GEAR
REMOVAL
(1) Raise vehicle.
(2) Remove components necessary to gain access to
rotor and drive gear such as propeller shaft, transfer
case, crossmember, and shift linkage.
(3) Disengage wire connector from the output
speed sensor.
(4) Remove the bolt holding the output speed sen-
sor to the adapter housing.
(5) Remove the output speed sensor from the
adapter housing.
(6) Remove the bolts holding the adapter housing
to the transmission case.
(7) Tap the adapter housing at the joint line gently
with a rubber mallet to separate the adapter housing
from the transmission case.
(8) Remove the adapter housing from the trans-
mission case.
(9) Remove speedometer drive gear snap ring (Fig.
53).
(10) Remove
the
speedometer
drive
gear
and
spacer, if equipped.
(11) Remove rotor from the output shaft. It may be
necessary to use a wood dowel or hammer handle
(Fig. 54) to gently pry the rotor from the output
Fig. 51 Speedometer Pinion Adapter Components
1 – SENSOR O-RING
2 – SPEEDOMETER ADAPTER
3 – ADAPTER O-RING
4 – SPEEDOMETER PINION
5 – ADAPTER CLAMP
6 – VEHICLE SPEED SENSOR
ITEM
TORQUE
A
2-3 N·m (15-27 in. lbs.)
B
10-12 N·m (90-110 in. lbs.)
Fig. 52 Index Numbers On Speedometer Pinion
Adapter
1 – SPEEDOMETER ADAPTER
2 – INDEX NUMBER LOCATION
21 - 254
AW–4 AUTOMATIC TRANSMISSION
XJ
REMOVAL AND INSTALLATION (Continued)