Jeep Cherokee 2000 Service Manual - Lamp Systems
LAMP SYSTEMS
TABLE OF CONTENTS
page
page
REMOVAL AND INSTALLATION
SENTINEL HEADLAMP DELAY MODULE . . . . . . . 19
DAYTIME RUNNING LAMP MODULE . . . . . . . . . . 19
REMOVAL AND INSTALLATION
SENTINEL HEADLAMP DELAY MODULE
REMOVAL
(1) Remove the knee blocker.
(2) Remove the screw that attaches the module to
the inside of the instrument panel (Fig. 1).
(3) Disconnect the wire harness connector and
remove the module from the instrument panel.
INSTALLATION
(1) Position the module inside the I/P and connect
the wire harness connector to the module.
(2) Install the screw that attaches the module to
the inside of the instrument panel.
(3) Install the knee blocker.
DAYTIME RUNNING LAMP MODULE
REMOVAL
The Daytime Running Lights (DRL) module is
located on the right fender inner panel adjacent to
the dash panel (Fig. 2).
(1) Disconnect the wire harness connector from the
module.
(2) Remove the screws that attach the module to
the fender inner panel.
(3) Remove the module from the fender inner
panel.
INSTALLATION
(1) Position the module on the right fender inner
panel.
(2) Install
the
attaching
screws.
Tighten
the
screws securely.
(3) Connect the wire harness connector to the mod-
ule.
Fig. 1 Headlamp Delay Module
1 – BRACKET
2 – HEADLAMP DELAY MODULE
Fig. 2 Daytime Running Lamp Module
1 – DAYTIME RUNNING LIGHT MODULE
XJ
LAMPS
8L - 19