Jeep Cherokee 2000 Service Manual - page 449
(8) Reverse the removal procedures to install.
Always use a new rubber grommet seal on the reser-
voir.
WASHER FLUID LEVEL SENSOR
(1) Remove the washer reservoir from the vehicle.
See Washer Reservoir in this group for the proce-
dures.
NOTE: The pivoting float of the washer fluid sensor
must be in a horizontal position within the reservoir
in order to be removed. With the reservoir empty
and in an upright position, the pivoting float will ori-
ent itself to the horizontal position when the sensor
connector is pointed straight downwards.
(2) Using a trim stick or another suitable wide
flat-bladed tool, gently pry the washer fluid level sen-
sor out of the rubber grommet seal. Care must be
taken not to damage the reservoir.
(3) Remove the rubber grommet seal from the res-
ervoir and discard.
(4) Reverse the removal procedures to install.
Always use a new rubber grommet seal on the reser-
voir.
WASHER NOZZLE
FRONT
(1) Remove the wiper arms from the wiper pivots.
See Wiper Arm in this group for the procedures.
(2) Remove the eight screws that secure the cowl
plenum cover/grille panel and screen to the cowl top
panel (Fig. 18).
(3) Carefully lift the cowl plenum cover/grille panel
and screen from the vehicle far enough to access the
windshield washer plumbing. Use care so as not to
damage the paint around the pivot openings of the
panel.
(4) Disconnect the windshield washer supply hose
and the passenger side washer nozzle hose from the
washer nozzle supply hose tee fitting.
(5) Remove the cowl plenum cover/grille panel and
screen from the vehicle.
(6) From the underside of the cowl plenum cover/
grille panel, disconnect the washer hose from the
nozzle fitting.
(7) From the underside of the cowl plenum cover/
grille panel, remove the rivet that secures the nozzle
to the opening in the cowl plenum cover/grille panel.
(8) Remove the washer nozzle from the cowl ple-
num cover/grille panel.
(9) Reverse the removal procedures to install.
REAR
(1) Unsnap the rear washer nozzle from the rear
wiper arm (Fig. 19).
Fig. 18 Front Washer Nozzles Remove/Install
1 – RIVET
2 – GRILLE PANEL
3 – SCREW
4 – SCREEN
5 – WASHER HOSE
6 – TEE
7 – NOZZLE
Fig. 19 Rear Washer Nozzle Remove/Install
1 – TO CHECK VALVE AND BODY SUPPLY HOSE
2 – LIFTGATE
3 – GROMMET
4 – NOZZLE
5 – GUARD
6 – HOSE
7 – CLIP
8 – BEZEL
9 – LIFTGATE SUPPLY HOSE
8K - 14
WIPER AND WASHER SYSTEMS
XJ
REMOVAL AND INSTALLATION (Continued)