Jeep Cherokee 2000 Service Manual - page 1289
(5) Install steering damper onto drag link and
install nut. Tighten nut to 74 N·m (55 ft. lbs.) and
install a new cotter pin.
STEERING DAMPER
REMOVAL
(1) Remove the steering damper retaining bolt
from the axle bracket.
(2) Remove the cotter pin and nut from the ball
stud at the drag link.
(3) Remove the steering damper ball stud from the
drag link with Puller C-3894-A.
INSTALLATION
(1) Install steering damper onto the axle bracket
and drag link.
(2) Install steering damper bolt in axle bracket
and tighten nut to 75 N·m (55 ft. lbs.).
(3) Install ball stud nut at the drag link and
tighten nut to 75 N·m (55 ft. lbs.). Install a new cot-
ter pin.
SPECIFICATIONS
TORQUE CHART
DESCRIPTION
TORQUE
Pitman Arm
Shaft . . . . . . . . . . . . . . . . . 251 N·m (185 ft. lbs.)
Drag Link
Ball Studs . . . . . . . . . . . . . . . 74 N·m (55 ft. lbs.)
Clamp . . . . . . . . . . . . . . . . . . 49 N·m (36 ft. lbs.)
Tie Rod Ends
Ball Studs . . . . . . . . . . . . . . . 74 N·m (55 ft. lbs.)
Clamp . . . . . . . . . . . . . . . . . . 27 N·m (20 ft. lbs.)
Tie Rod
Ball Stud . . . . . . . . . . . . . . . . 47 N·m (35 ft. lbs.)
Steering Damper
Frame . . . . . . . . . . . . . . . . . . 74 N·m (55 ft. lbs.)
Drag Link . . . . . . . . . . . . . . . 74 N·m (55 ft. lbs.)
SPECIAL TOOLS
STEERING LINKAGE
Puller C-3894–A
Remover Pitman C-4150A
XJ
STEERING
19 - 25
REMOVAL AND INSTALLATION (Continued)