Jeep Cherokee 2000 Service Manual - page 1586
(35) Install planetary snap ring on sun gear with
snap ring plier tool 7541 (Fig. 155).
(36) Install tabbed thrust race on front planetary
gear. Washer tabs face down and toward gear. Race
outer diameter is 47.8 mm (1.882 in.). Inside diame-
ter is 34.3 mm (1.350 in.).
(37) Install second coast brake band (Fig. 156).
(38) Install pin in second coast brake band. Then
install retaining ring on pin (Fig. 157).
(39) Install thrust bearing and race in forward–di-
rect clutch (Fig. 158). Coat bearing/race with petro-
leum jelly to hold them in place.
(40) Verify forward–direct clutch thrust bearing
size.
•
Race outer diameter is 48.9 mm (1.925 in.) and
inside diameter is 26.0 mm (1.024 in.).
•
Bearing outer diameter is 46.7 mm (1.839 in.)
and inside diameter is 26.0 mm (1.024 in.).
(41) Coat front planetary ring gear race with
petroleum jelly and install it in ring gear (Fig. 159).
Fig. 155 Installing Front Planetary Snap Ring
1 – SNAP RING PLIER TOOL
2 – FRONT PLANETARY
3 – SNAP RING
Fig. 156 Installing Second Coast Brake Band
1 – SECOND COAST BRAKE BAND
Fig. 157 Installing Second Coast Brake Band
Retaining Pin
1 – SECOND COAST BRAKE BAND
2 – BAND RETAINING PIN
3 – RETAINING RING (INSTALL ON PIN)
21 - 286
AW–4 AUTOMATIC TRANSMISSION
XJ
DISASSEMBLY AND ASSEMBLY (Continued)