Jeep Cherokee 2000 Service Manual - page 1737
WARNING: DO NOT USE SOLVENT BASED GLASS
CLEANER
TO
CLEAN
WINDSHIELD
BEFORE
APPLYING
GLASS
PREP AND
PRIMER.
POOR
ADHESION CAN RESULT.
(8) Clean inside of glass with Mopar Glass Cleaner
and lint-free cloth.
(9) Apply PVC (vinyl) primer 25 mm (1 in.) wide
around edge of glass. Wipe with clean/dry lint-free
cloth.
(10) If necessary, apply fence primer around edge
of fence. Allow at least eighteen minutes drying time.
(11) Apply a 10 mm (0.4 in.) bead of urethane
around glass border.
(12) Position glass into liftgate opening and refer-
ence marks.
(13) Push the glass inward until the reveal mold-
ing is seated onto the liftgate frame. Use care to
avoid excessive squeeze-out of adhesive.
(14) Open windows to prevent pressure build-up
while the urethane is curing.
(15) Apply 150 mm (6 in.) lengths of 50 mm (2 in.)
masking tape spaced 250 mm (10 in.) apart to hold
glass in place until urethane cures.
(16) Install the wiper arm.
(17) Install CHMSL lens.
(18) Connect heated backlite (HBL) connector.
(19) After urethane has cured, remove tape strips
and water test to verify repair.
(20) Install liftgate trim panel.
23 - 12
BODY
XJ
REMOVAL AND INSTALLATION (Continued)