Jeep Cherokee 2000 Service Manual - page 554
NOTE: To aid in the removal of the trim panel, start
at the bottom of the panel.
(5) Lift the front door trim panel upwards and
away from the inner door panel far enough to disen-
gage the top of the panel from the inner belt weath-
erstrip.
(6) Pull the front door trim panel away from the
inner door far enough to access the inside door latch
release and lock linkage rods near the back of the
inside door remote controls.
(7) Unsnap the plastic retainer clips from the
inside door remote control ends of the latch release
and lock linkage rods, and remove the rod ends from
the inside door remote controls.
(8) Unplug the wire harness connectors from the
door power switch module or, on the driver side only,
the stand-alone power mirror switch.
(9) Set the front door trim panel aside.
(10) Remove the one screw that secures the front
door flag trim to the inner door panel (Fig. 10).
(11) Using a trim stick or another suitable wide
flat-bladed tool, gently pry the door flag trim away
Fig. 6 Door Module Remove/Install
1 – INSIDE DOOR LATCH AND LOCK REMOTE CONTROLS
2 – CONNECTOR 1 RECEPTACLE
3 – DOOR MODULE
4 – CONNECTOR 2 RECEPTACLE
5 – SCREWS
6 – DOOR TRIM PANEL
Fig. 7 Window Regulator Crank Handle Remove -
Typical
1 – DOOR HANDLE REMOVAL TOOL
2 – WINDOW CRANK
Fig. 8 Front Door Trim Panel Remove/Install -
Manual Window
1 – U-NUT
2 – DOOR
3 – TRIM PANEL
4 – WINDOW CRANK
5 – SPACER
6 – PUSH-IN FASTENER
Fig. 9 Front Door Trim Panel Remove/Install - Power
Window
1 – U-NUT
2 – DOOR
3 – TRIM PANEL
4 – PUSH-IN FASTENER
XJ
POWER MIRROR SYSTEMS
8T - 5
REMOVAL AND INSTALLATION (Continued)