Jeep Cherokee 2000 Service Manual - page 1887
lator outlet tube refrigerant line coupler. See Refrig-
erant Line Coupler in this group for the procedures.
(5) Plug the wire harness connector into the low
pressure cycling clutch switch.
(6) Connect the battery negative cable.
(7) Evacuate the refrigerant system. See Refriger-
ant System Evacuate in this group for the proce-
dures.
(8) Charge the refrigerant system. See Refrigerant
System Charge in this group for the procedures.
NOTE: If the accumulator is replaced, add 120 mil-
liliters (4 fluid ounces) of refrigerant oil to the
refrigerant system. Use only refrigerant oil of the
type recommended for the compressor in the vehi-
cle.
BLEND-AIR DOOR MOTOR
WARNING: ON VEHICLES EQUIPPED WITH AIR-
BAGS,
REFER
TO
GROUP
8M
-
PASSIVE
RESTRAINT SYSTEMS BEFORE ATTEMPTING ANY
STEERING
WHEEL,
STEERING
COLUMN,
OR
INSTRUMENT PANEL COMPONENT DIAGNOSIS OR
SERVICE. FAILURE TO TAKE THE PROPER PRE-
CAUTIONS COULD RESULT IN ACCIDENTAL AIR-
BAG DEPLOYMENT AND POSSIBLE PERSONAL
INJURY.
REMOVAL
(1) Disconnect and isolate the battery negative
cable.
(2) Disconnect the wire connector from the blend-
air door motor.
(3) Remove the screws that secure the blend-air
door motor to the housing (Fig. 15).
(4) Remove the blend-air door motor.
INSTALLATION
(1) Reverse the removal procedures for installa-
tion.
(2) Install and tighten the screws that secures the
blend-air door motor to the housing. Tighten the
mounting screws to 1 N·m (10 in. lbs.).
(3) Connect the battery negative cable.
BLOWER MOTOR
REMOVAL
(1) If the vehicle is equipped with air conditioning,
recover the refrigerant from the refrigerant system.
See Refrigerant Recovery in this group for the proce-
dures.
(2) Disconnect and isolate the battery negative
cable.
(3) If the vehicle is equipped with air conditioning,
the accumulator must be relocated in order to service
the blower motor. This is done by loosening the accu-
mulator retaining band screw and disconnecting the
accumulator inlet tube from the evaporator outlet
tube. The accumulator can then be moved far enough
to access and remove the blower motor. See Accumu-
lator in this group for the procedures.
(4) Unplug the blower motor wire harness connec-
tor (Fig. 16).
(5) Remove the three screws that secure the
blower motor and wheel assembly to the heater-A/C
housing.
(6) Rotate and tilt the blower motor unit as needed
for clearance to remove the blower motor and wheel
from the heater-A/C housing.
INSTALLATION
(1) Align and install the blower motor and wheel
assembly into the heater-A/C housing.
(2) Install and tighten the three screws that secure
the blower motor and wheel assembly to the heater-
A/C housing. Tighten the mounting screws to 2.2
N·m (20 in. lbs.).
(3) Plug in the blower motor wire harness connec-
tor.
(4) If the vehicle is equipped with air conditioning,
connect the accumulator inlet tube to the evaporator
outlet tube and tighten the accumulator retaining
band screw. See Accumulator in this group for the
procedures.
(5) Connect the battery negative cable.
Fig. 15 Blend-Air Door Motor
1 – ELECTRICAL CONNECTOR
2 – BLEND-AIR DOOR MOTOR
3 – SCREW MOUNTING POINTS
24 - 26
HEATING AND AIR CONDITIONING
XJ
REMOVAL AND INSTALLATION (Continued)