Jeep Cherokee 2000 Service Manual - page 1633
(5) Coat planetary thrust washers with petroleum
jelly and install them in gear (Fig. 294).
(6) Install No. 2 one–way clutch bottom end cap
into the planetary gear.
(7) Install No. 2 one–way clutch in planetary gear.
Be sure flanged side of clutch faces upward (Fig.
297).
(8) Install No. 2 one–way clutch top end cap into
the planetary gear.
(9) Install clutch retaining snap ring and install
clutch inner race (Fig. 292). Turn race counterclock-
wise to ease installation.
(10) Verify one–way clutch operation. Hold gear
and turn inner race in both directions. Race should
turn freely counterclockwise, but lock when turned
clockwise.
(11) Install planetary gear in ring gear.
(12) Install thrust bearing and washers onto the
ring gear (Fig. 295).
(13) Assemble clutch discs and clutch plates (Fig.
289). Sequence is disc first, then a plate. Use seven
discs and plates.
(14) Install brake pack on planetary gear (Fig.
289).
(15) Install new seal ring on output shaft (Fig.
288). Be sure ring ends are interlocked as shown.
TRANSMISSION VALVE BODY
The valve body assembly consists of two sections
which are the upper body and lower body (Fig. 298)
and (Fig. 299). Disassembly, inspection and overhaul
procedures for each section are outlined separately.
Refer to the appropriate procedure as needed.
Fig. 297 Installing No. 2 One–Way Clutch
1 – FLANGED SIDE OF CLUTCH
2 – NO. 2 ONE-WAY CLUTCH
3 – REAR PLANETARY
XJ
AW–4 AUTOMATIC TRANSMISSION
21 - 333
DISASSEMBLY AND ASSEMBLY (Continued)