Jeep Cherokee 2000 Service Manual - page 243
CONDITION
POSSIBLE CAUSES
CORRECTION
Clutch pedal squeak.
1. Pivot pin loose.
1. Tighten pivot pin if possible.
Replace clutch pedal if necessary.
2. Master cylinder bushing not
lubricated.
2. Lubricate master cylinder
bushing.
3. Pedal bushings worn out or
cracked.
3. Replace and lubricate bushings.
Clutch master or slave cylinder
plunger dragging andør binding
1. Master or slave cylinder
components worn or corroded.
1. Replace clutch hydraulic linkage
assembly.
Release bearing is noisy.
1. Release bearing defective or
damaged.
1. Replace release bearing.
Contact surface of release bearing
damaged.
1. Clutch cover incorrect or release
fingers bent or distorted.
1. Replace clutch cover and release
bearing.
2. Release bearing defective or
damaged.
2. Replace the release bearing.
3. Release bearing misaligned.
3. Check and correct runout of
clutch components. Check front
bearing sleeve for damage/
alignment. Repair as necessary.
Partial engagement of clutch disc.
One side of disc is worn and the
other side is glazed and lightly
worn.
1. Clutch pressure plate position
incorrect.
1. Replace clutch disc and cover.
2. Clutch cover, spring, or release
fingers bent or distorted.
2. Replace clutch disc and cover.
3. Clutch disc damaged or
distorted.
2. Replace clutch disc.
4. Clutch misalignment.
4. Check alignment and runout of
flywheel, disc, pressure plate, andør
clutch housing. Correct as
necessary.
SERVICE PROCEDURES
CLUTCH COMPONENT LUBRICATION
Proper clutch component lubrication is important
to satisfactory operation. Using the correct lubricant
and not over lubricating are equally important. Apply
recommended lubricant sparingly to avoid disc and
pressure plate contamination.
Clutch and transmission components requiring
lubrication are:
•
Pilot bearing.
•
Release lever pivot ball stud.
•
Release lever contact surfaces.
•
Release bearing bore.
•
Clutch disc hub splines.
•
Clutch pedal pivot shaft bore.
•
Clutch pedal bushings.
•
Input shaft splines.
•
Input shaft pilot hub.
•
Transmission front bearing retainer slide sur-
face.
NOTE: Never apply grease to any part of the clutch
cover, or disc.
RECOMMENDED LUBRICANTS
Use Mopar
t
multi-purpose grease for the clutch
pedal bushings and pivot shaft. Use Mopar
t
high
temperature grease (or equivalent) for all other lubri-
cation requirements. Apply recommended amounts
and do not over lubricate.
CLUTCH LINKAGE FLUID
If inspection or diagnosis indicates additional fluid
may be needed, use Mopar
t
brake fluid, or an equiv-
XJ
CLUTCH
6 - 9
DIAGNOSIS AND TESTING (Continued)