Jeep Cherokee 2000 Service Manual - page 1120
(17) Disconnect the oil drain line from turbo-
charger.
(18) Remove the Exhaust manifold. Refer to Group
11, Exhaust System and Turbocharger.
(19) Remove the Intake manifold. Refer to intake
manifold removal and installation procedure in this
section.
(20) Remove the oil feed line retaining bracket at
rear of #4 cylinder head.
(21) Remove the oil feed line retaining bracket
(Fig. 29).
(22) Remove the oil feed line for rocker arm
assemblies (Fig. 30).
(23) Remove the Crankcase breather hose from
rear of the valve cover
(24) Remove the injector sensor wire and the glow
plug hot lead.
(25) Remove the fuel lines and fuel filter. Refer to
Group 14, Fuel Systems for procedure.
(26) Remove the injector fuel lines from injectors
to pump.
(27) Remove the fuel injectors with tool VM.1012
(Fig. 31). Refer to Group 14, Fuel System for proce-
dure.
(28) Remove the engine cylinder head cover.
(29) Remove the rocker retaining nuts (Fig. 33).
(30) Remove the rocker arm assemblies. Place
them on a bench in the same order as removed.
(31) Remove the push rods and place them on a
bench in the same order as removed.
(32) Mark the cylinder head positions.
(33) Remove the engine cylinder head bolts with
special tool VM.1018 and VM.1019.
(34) Remove the engine cylinder head and gasket.
(35) Stuff clean lint free shop towels into the cyl-
inder bores.
CYLINDER HEAD GASKETS
A steel cylinder head gasket is used for all four cyl-
inder heads.
Cylinder head gaskets are available in three thick-
nesses. Identification holes in the right front corner
of the gasket indicate the thickness of the gasket
(Fig. 34).
Fig. 29 Oil Feed Line Retainer
1 – CYLINDER HEAD OIL SUPPLY LINE RETAINING CLIP
2 – EXHAUST MANIFOLD
3 – CYLINDER HEAD OIL SUPPLY LINE
4 – REAR OF CYLINDER HEADS
5 – CYLINDER HEAD COVER
Fig. 30 Rocker Arm Oil Feed Lines
Fig. 31 Fuel Injector Tool VM.1012B
9 - 26
ENGINE
XJ
REMOVAL AND INSTALLATION (Continued)