Jeep Cherokee 2000 Service Manual - page 218
(4) Install combination valve/bracket and retaining
nuts.
(5) Install brake lines on cylinder and valve.
Torque brake lines to 19 N·m (170 in. lbs.).
(6) Connect differential pressure switch wire on
the combination valve.
(7) Fill and bleed the brake system. Refer to the
procedure in this group.
(8) Connect the negative battery cable.
(9) Adjust the brake lamp switch. Refer to the pro-
cedure in this group.
WARNING: Be
certain
a
firm
brake
pedal
is
achieved prior to attempting to operate the vehicle.
SPECIFICATIONS
TORQUE SPECIFICATIONS
DESCRIPTION
TORQUE
Brake Booster to Cowl Panel
Nuts . . . . . . . . . . . . . . . . . . . . . 39 N·m (29 ft. lbs.)
Brake Lines at Master Cylinder and
Combination Valve
Tube Nuts . . . . . . . . . . . . . . . . 19 N·m (170 in. lbs.)
Master Cylinder to Vacuum Booster
Nuts . . . . . . . . . . . . . . . . . . . 17.5 N·m (155 in. lbs.)
5 - 4
BRAKES
XJ
REMOVAL AND INSTALLATION (Continued)