Jeep Cherokee 2000 Service Manual - page 1561
module from the finish panel. Tighten the module
mounting screws securely after installation. Also be
sure the wire harness is not twisted, kinked or touch-
ing any body panels.
SOLENOID HARNESS ADAPTER SEAL
REMOVAL
(1) Remove oil pan and oil screen.
(2) Disconnect solenoid wire connectors (Fig. 72).
(3) Remove
bracket
securing
solenoid
harness
adaptor (Fig. 73) to case.
(4) Pull harness adapter and wires out of case.
Fig. 69 Installing Transmission Valve Body Oil
Tubes
Fig. 70 TCM Location (Left Hand Drive)
1 – TCM
2 – LOWER FINISH PANEL
Fig. 71 TCM Location (Right Hand Drive)
1 – REAR SIDE OF INSTRUMENT PANEL
2 – TCM AND HARNESS
Fig. 72 Solenoid Wire Connectors
1 – SOLENOID WIRE CONNECTORS
Fig. 73 Harness Adapter Removal/Installation
1 – HARNESS ADAPTER
2 – BRACKET
XJ
AW–4 AUTOMATIC TRANSMISSION
21 - 261
REMOVAL AND INSTALLATION (Continued)