Jeep Cherokee 2000 Service Manual - page 548
(7) Unplug the wire harness connectors from the
door module.
(8) Remove the trim panel from the front door.
(9) Remove the three screws that secure the door
module to the front door trim panel (Fig. 5).
(10) Remove the door module from the front door
trim panel.
(11) Reverse the removal procedures to install.
Tighten the mounting screws to 2.2 N·m (20 in. lbs.).
POWER WINDOW SWITCH
(1) Disconnect and isolate the battery negative
cable.
(2) Remove the screws that secure the door trim
panel to the inner door panel (Fig. 6).
(3) Using a trim stick or another suitable wide
flat-bladed tool, gently pry the rear door trim panel
away from the door around the perimeter to release
the trim panel retainers.
NOTE: To aid in the removal of the trim panel, start
at the bottom of the panel.
(4) Lift the rear door trim panel upwards and
away from the inner door panel far enough to disen-
gage the top of the panel from the inner belt weath-
erstrip.
(5) Pull the rear door trim panel away from the
inner door panel far enough to access the inside door
latch release and lock linkage rods near the back of
the inside door remote controls.
(6) Unsnap the plastic retainer clips from the
inside door remote control ends of the latch release
and lock linkage rods, and remove the rod ends from
the inside door remote controls.
(7) Unplug the wire harness connector from the
rear door power window switch.
(8) Remove the trim panel from the rear door.
(9) With a small thin-bladed screwdriver, gently
pry the snap clips at the sides of the power window
switch receptacle on the back of the rear door trim
panel and pull the switch out of the receptacle (Fig.
7).
(10) Reverse the removal procedures to install. Be
certain that both of the switch snap retainers in the
receptacle on the back of the trim panel are fully
engaged.
Fig. 4 Front Door Trim Panel Remove/Install
1 – U-NUT
2 – DOOR
3 – TRIM PANEL
4 – PUSH-IN FASTENER
Fig. 5 Door Module Remove/Install
1 – INSIDE DOOR LATCH AND LOCK REMOTE CONTROLS
2 – CONNECTOR 1 RECEPTACLE
3 – DOOR MODULE
4 – CONNECTOR 2 RECEPTACLE
5 – SCREWS
6 – DOOR TRIM PANEL
Fig. 6 Rear Door Trim Panel Remove/Install
1 – U-NUT
2 – REAR DOOR
3 – TRIM PANEL
4 – PUSH-IN FASTENER
XJ
POWER WINDOW SYSTEMS
8S - 5
REMOVAL AND INSTALLATION (Continued)