Jeep Cherokee 2000 Service Manual - Lamp Service
LAMP SERVICE
TABLE OF CONTENTS
page
page
REMOVAL AND INSTALLATION
HEADLAMP . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8
HEADLAMP LEVELING MOTOR. . . . . . . . . . . . . . . 8
SIDE REPEATER LAMP . . . . . . . . . . . . . . . . . . . . . 9
FRONT FOG LAMP . . . . . . . . . . . . . . . . . . . . . . . . 9
REAR TURN SIGNAL, BACKUP, TAILLAMP
AND FOG LAMP . . . . . . . . . . . . . . . . . . . . . . . . . 9
LICENSE PLATE LAMP . . . . . . . . . . . . . . . . . . . . . 9
REMOVAL AND INSTALLATION
HEADLAMP
REMOVAL
(1) Remove the 2 screws holding the headlamp
bezel in place and remove bezel (Fig. 1).
(2) Remove the 4 screws holding the headlamp
(Fig. 2).
(3) Pull the front position lamp straight from
headlamp.
(4) Disconnect the headlamp electrical connector
by pulling straight off.
(5) Remove the headlamp from the vehicle.
INSTALLATION
(1) Install front position lamp in headlamp.
(2) Connect headlamp electrical connector.
(3) Position the headlamp, headlamp retaining
ring and install the retaining screws.
(4) Position the headlamp bezel and install retain-
ing screws.
HEADLAMP LEVELING MOTOR
REMOVAL
(1) Open the hood and disconnect the negative bat-
tery cable.
(2) Raise the vehicle on a hoist or position a
creeper under the front of the vehicle.
(3) Remove
the
appropriate
side
front
splash
shield. Located just in front of the front wheel.
Fig. 1 Headlight Bezel Retaining Screws
Fig. 2 Headlamp Retaining Screws
Fig. 3 Headlamp Leveling Motor
1 – HEADLAMP LEVELING MOTOR
2 – FRONT STABILIZER BAR
8L - 8
LAMPS
XJ