Jeep Cherokee 2000 Service Manual - page 1580
(61) Remove No. 2 first–reverse brake piston with
compressed air. Apply air through same transmission
feed hole used for checking piston operation.
(62) Remove reaction sleeve with Sleeve Remover
Tool 7542 (Fig. 136). Insert tool flanges under sleeve
and lift tool and sleeve out of case.
(63) Remove No. 1 first/reverse brake piston with
Piston Puller 7543 (Fig. 137). Slip tool under piston
and lift tool and piston out of case.
ASSEMBLY
(1) During assembly, lubricate components with
transmission fluid or petroleum jelly as indicated.
(2) Verify thrust bearing and race installation dur-
ing assembly. Refer to the Thrust Bearing Chart (Fig.
Fig. 135 Removing/Installing Piston Snap Ring
1 – RETURN SPRINGS
2 – COMPRESSOR TOOL
3 – PISTON SNAP RING
Fig. 134 Checking First–Reverse Brake Piston
Operation
1 – LOW-PRESSURE AIR
2 – FIRST-REVERSE BRAKE (IN CASE)
Fig. 136 Removing/Installing Reaction Sleeve
1 – REACTION SLEEVE
2 – TOOL
Fig. 137 Removing/Installing First–Reverse Brake
No.1 Piston
1 – NO. 1 PISTON
2 – TOOL
21 - 280
AW–4 AUTOMATIC TRANSMISSION
XJ
DISASSEMBLY AND ASSEMBLY (Continued)