Jeep Cherokee 2000 Service Manual - page 252
(10) Install the transmission and transfer case.
Refer to Group 21, Transmission and Transfer Case
for procedure.
PILOT BEARING
REMOVAL
(1) Remove the transmission and transfer case.
Refer to Group 21, Transmission and Transfer Case
for procedures.
(2) Remove the clutch cover and disc (Fig. 6). Refer
to clutch cover and disc removal and installation in
this group.
(3) Remove the four bolts that attach the pilot
bearing retainer to the flywheel (Fig. 7).
(4) Remove the pilot bearing retainer.
(5) Support the bearing retainer on two wood
blocks.
(6) Remove the pilot bearing with a suitable sized
socket and extension (Fig. 8). Use mallet to tap bear-
ing out of retainer.
Fig. 4 Clutch Disc Alignment – Typical
1 – FLYWHEEL
2 – CLUTCH COVER AND DISC
3 – CLUTCH DISC ALIGNMENT TOOL
Fig. 5 Clutch Cover (Pressure Plate) View
1 – VEHICLE UNDERBODY
2 – ENGINE SPEED SENSOR
3 – PRESSURE PLATE RETAINING BOLTS
4 – CLUTCH COVER (PRESSURE PLATE)
5 – ENGINE OIL PAN
6 – PRESSURE PLATE RETAINING BOLTS
Fig. 6 Clutch Cover (Pressure Plate) View
1 – VEHICLE UNDERBODY
2 – ENGINE SPEED SENSOR
3 – PRESSURE PLATE RETAINING BOLTS
4 – CLUTCH COVER (PRESSURE PLATE)
5 – ENGINE OIL PAN
6 – PRESSURE PLATE RETAINING BOLTS
XJ
CLUTCH
6 - 3
REMOVAL AND INSTALLATION (Continued)