Jeep Cherokee 2000 Service Manual - page 467
INSTALLATION
(1) Position underhood lamp on hood inner panel.
Ensure anti-rotation tab is positioned in slot on hood
inner panel.
(2) Install the attaching screw through the lamp
and into the hood panel (Fig. 8). Tighten the screw
securely.
(3) Fold lamp housing over and firmly press onto
base to snap into place.
(4) Connect the wire harness connector to the
lamp.
CARGO LAMP
REMOVAL
(1) Insert a small flat blade into the access slots
(Fig. 9).
(2) Carefully pry the lens from the lamp.
(3) Disengage the lens mounting tabs from the
lamp mounting pins (Fig. 10).
(4) Remove the fasteners attaching the lamp to the
roof.
(5) Remove the lamp housing from the headliner
cavity.
(6) Disconnect the wire harness connector.
INSTALLATION
(1) Position the dome lamp housing at the head-
liner cavity.
(2) Connect the wire harness connector.
(3) Install the fasteners attaching the lamp to the
roof.
(4) Position the lens at the lamp housing and force
it upward into the housing until the mounting tabs
are seated on the lamp mounting pins.
MAP/READING LAMP
The map/reading lamp can be serviced by removing
the overhead console. Refer to Group 8C, Overhead
Console for removal/installation procedures.
Fig. 8 Underhood Lamp
1 – HOOD
2 – UNDERHOOD LAMP/SWITCH
Fig. 9 Cargo Lamp
1 – HOUSING
2 – SCREWDRIVER SLOTS
3 – CARGO LAMP
4 – LENS
Fig. 10 Cargo Lamp Lens
1 – MOUNTING PIN ON UNDERSIDE
2 – BULB
3 – MOUNTING PIN
4 – MOUNTING TAB
5 – TAB “A”
6 – MOUNTING TAB
7 – SLOT “B”
XJ
LAMPS
8L - 17
REMOVAL AND INSTALLATION (Continued)