Jeep Cherokee 2000 Service Manual - page 1298
(19) Remove the engine mount throughbolt.
(20) Remove the engine mount and engine mount
bracket from vehicle.
(21) Remove the (2) power steering pump retaining
nuts (Fig. 10).
(22) Slide pump off mounting studs and position so
pressure line can be removed. This will require you
to install pressure line on the new pump prior to
installing it in the engine block.
(23) Remove the power steering pump from the
vehicle.
Installation
WARNING: Power steering system fluid may be
contaminated with metal shavings, overheated or
improper fluid. All fluid should be drained from the
system.
After
component
replacement,
system
should be flushed and filled with Mopar Power
Steering Fluid, or equivalent.
(1) Install the pressure line on pump in original
position.
(2) Transfer the drive coupler to new pump leaving
pinch bolt lose at this time (Fig. 11).
(3) Install the power steering pump in the engine
block. Torque retaining nuts to 24 N·m (18 ft. lbs.)
(Fig. 11).
(4) Install the engine mount and engine mount
bracket in vehicle.
Fig. 9 Removing Pump Pulley
1 – LEVERAGE PIPE
2 – HEX WRENCH
3 – POWER STEERING PUMP PULLEY
4 – BOX WRENCH
Fig. 10 Power Steering Pump
1 – ENGINE BLOCK
2 – COUPLER
3 – COUPLER PINCH BOLT
4 – POWER STEERING PUMP RETAINING NUTS
Fig. 11 Power Steering Pump
1 – ENGINE BLOCK
2 – COUPLER
3 – COUPLER PINCH BOLT
4 – POWER STEERING PUMP RETAINING NUTS
19 - 6
STEERING
XJ
REMOVAL AND INSTALLATION (Continued)