Jeep Cherokee 2000 Service Manual - page 1776
A-PILLAR TRIM
REMOVAL
(1) Remove front and rear assist handles, if
equipped.
(2) Remove the inner scuff plate.
(3) Remove the lower A-pillar cowl trim.
(4) Using a small flat blade, pry the trim plugs
from the A-pillar trim.
(5) Remove the screws attaching the A-pillar trim
to the A-pillar (Fig. 65).
(6) Separate the A-pillar trim from the A-pillar.
INSTALLATION
(1) Position the A-pillar trim on the A-pillar.
(2) Install the screws attaching the A-pillar trim to
the A-pillar.
(3) Install the trim plugs.
(4) Install the lower A-pillar cowl trim.
(5) Install the inner scuff plate.
(6) Install the assist handles.
LOWER A-PILLAR COWL TRIM
REMOVAL
(1) Remove the inner scuff plate.
(2) Remove the nut behind the fuse panel access
door (Right side only) (Fig. 66).
(3) Remove the fasteners attaching the lower A-pil-
lar cowl trim to the A-pillar lower cowl.
(4) Separate the lower A-pillar cowl trim from the
A-pillar lower cowl.
Fig. 65 Trim Panels—2-Door Vehicles
1 – SPACER
2 – LIFTGATE PILLAR TRIM
3 – UPPER QUARTER PANEL TRIM
4 – COAT HOOK
5 – WHEELHOUSE COVER
6 – LOWER QUARTER PANEL TRIM
7 – COVER
8 – LOWER B-PILLAR TRIM
9 – PUSH-IN FASTENER
10 – NUT
11 – INNER SCUFF PLATE
12 – ACCESS DOOR
13 – COWL PANEL TRIM
14 – TRIM PLUG
15 – OVERHEAD ASSIST HANDLE
16 – A-PILLAR TRIM
17 – UPPER B-PILLAR TRIM
XJ
BODY
23 - 51
REMOVAL AND INSTALLATION (Continued)