NEC SV8500 Operation And Maintenance Manual - page 118
– 71 –
CHAPTER 2
Operations of SV8500 Server
•
CPU Card Replacement Procedure for CPU Single Configuration
[Start]
STEP 1
Turn off the SV8500 server.
•
On the initial screen, select “System Control” and click “Execute” button.
•
Select “System Shutdown” in “Select Processing” list box.
•
Click “Execute” button to shut down the system.
•
Make sure that “PWR” lamp is off on the CPU card.
•
Turn off “Power” switch (press the right side of the switch) on the Power module.
Note:
Be sure to confirm “PWR” lamp is off on the CPU card before turning off “Power” switch on the Power
module.
When PCPro Tools - System Shutdown is not available or does not work, press “PWR” switch on CPU
card for four seconds to shut down the CPU card
.
•
Press “PWR” switch for four seconds on the CPU card.
•
Make sure that “PWR” lamp is off on the CPU card.
•
Turn off “Power” switch (press the right side of the switch) on the Power module.
Note:
Be sure to confirm “PWR” lamp is off on the CPU card before turning off “Power” switch on the Power
module.
STEP 2
Turn off the PIR (s) and TSWR when they are accommodated. If not skip this step.
Turn off the power (PWR/DPWR cards) in the following order.
•
PIR0
o
PIR1
o
PIR2
o
PIR3 (smaller number PIR first)
Turn off the power (PWR/DPWR cards) in the following order.
•
TSWR
•
PIR0
o
PIR1
o
PIR2
o
....
o
PIR15 (smaller number PIR first)
STEP 3
Disconnect the LAN cables from the front connector.
Note:
It is recommended to put a mark on the cable not to reconnect a wrong cable.
When the system is CPU single configuration, the whole system must be shut down.
WARNING