NEC SV8500 Operation And Maintenance Manual - page 167
– 120 –
CHAPTER 2
Operations of SV8500 Server
(5) Route Peg Count
The following shows Route Peg Count Listup Report and description of symbols in the report.
.
•
Report Type
(Route Peg Count Type)
: 1 = Intra Office Trunks
2 = IC/OG Trunks
•
Attempts
: The number of times that a trunk selection was attempted.
•
Block
: The number of times that trunk busy was encountered when accessing a
trunk.
•
Established
: The number of connections to trunks in the counting target office.
•
Outgoing
: The number of times trunks were accessed. The number does not always
coincide with the number obtained by subtracting “Block” from “At-
tempts”.
•
Incoming
: The number of call terminations.
•
Register Access
: The number of actual ORT/IRT register connections. In the case of
Bothway C.O. Trunks (CBWT), the number becomes “0”.
Also when register blocking has occurred, the “Incoming” number and
the “Register Access” number do not always coincide.
•
Attendant
: The number of incoming calls that directly terminate to the Attendant.
•
Station
: The number of incoming station to station calls (not via the Attendant
Console).
Note:
The traffic data on the above report is an example.
1
13
9
1
3
6
0
6
0
1
5
0
Start Time: 10/27 16:34
End Time: 10/27 16:40
10, 27, 2005
[LOCALHOST::DTFA]
* Display of Route Peg Count Data (DTF105) *
Attempts
Report Type Incoming/Outgoing Trunks Route 1
Block
Established Outgoing Incoming Register
Access
Attendant
23
3
26
19
6
19
6
Station
Tandem
Others VT(E-CCIS)
0
0
0
0
0
Establishment
[OUT]
VT(E-CCIS)
Establishment
[IN]
TRAFFIC MEASUREMENT
Page (UP)
Page (Down)
Save Text File