NEC SV8500 Operation And Maintenance Manual - page 234
– 187 –
CHAPTER 2
Operations of SV8500 Server
14. IP DEVICE PC PORT REMOTE CONTROL
14.1Overview
This feature allows the maintenance personnel to disconnect/connect the PC port of the IP Stations from/
to the network using PCPro. For example, the maintenance personnel can quickly disconnect the PC (that
is connected to the PC port of IP Station) from the network when virus is detected on the network.
14.2Operating Procedure
See “CPCP command” in Chapter 6.
14.3Service Conditions
(1) This feature is available for the following terminals:
IP Enabled Dterm (Dterm Series i): Ver. 3.06 or later
DtermIP (Proprietary Protocol): Ver. 3.08 or later
DtermIP (SIP): Ver. 3.0.0.0 or later
DT700 Series: Available since first version
(2) This feature can be executed while the terminals registered to the System.
(3) In the FCCS network, execute this feature on a node basis.
(4) The status of the PC port can be saved on a station number basis.
(5) The following shows the service conditions only for DtermIP (Proprietary Protocol).
(a) PC Port setting is canceled if the DtermIPs (Proprietary Protocol) register to the System again after
the terminal reset. Therefore, DtermIPs (Proprietary Protocol) needs to be placed in “PC Port shut-
down” status after each registration.
(b) This feature is not available for DtermIPs which have not yet registered to the System. It is required
to execute this feature after completing the registration.
(c) If this feature data (CPCP command) is set on the terminals in logout status, the set data does not take
effect even after the terminals log into the System. In this case, the CPCP command data setting is
required after the registration.
(d) To use this feature (CPCP command control), the following configuration setting on the terminal is
required.
•
Select “Automatic” from the User Menu
o
Ether Port Setting
o
PC Port Settings
o
Port Available
(PC).
When “Automatic” is selected:
If the software reset is executed, the status of the PC port can be maintained.
If the hardware reset is executed after turning off the terminal, the status of PC port is also reset (PC
port will be connected to the network).