NEC SV8500 Operation And Maintenance Manual - page 804
– 757 –
CHAPTER 7
Maintenance Commands
Note 2:
On Single SP, reset can be executed.
Note 3:
When reset transaction is executing, the remaining time until Time-out is displayed, if reset transaction
is not completed within 3 minutes, the task will be stopped with displaying “Time-out”.
SP mode change:
Execute forcible system changeover between Active-side SP and Standby-side
SP.
Note 1:
Only when system ID is specified in SIP Server ID and the system is redundant, this button is displayed.
Note 2:
Only when the SP is in Active mode and another SP is in Standby mode, system changeover can be ex-
ecuted.
Note 3:
When system changeover is executing, the remaining time until Time-out is displayed, if system change-
over is not completed within 3 minutes, the task will be stopped with displaying “Time-out”.