NEC SV8500 Operation And Maintenance Manual - page 924
– 877 –
CHAPTER 7
Maintenance Commands
MBPH: Make Busy of PHL Package for LDM
1. Functional Outline
This command is used to set the make-busy state of the PHL circuit card due to a card replacement. Executing
this command transfers the terminals belonging to the PHL circuit card to another PHL card which has unused
ports. Once the registration is transferred to another PHL circuit card, and make-busy on the previous circuit
card is cancelled, the registrations do not move back to the previous one. Selecting the circuit card lists the
related extension numbers and status on the display.
Note 1:
If the port number on the PHL circuit card to be transferred is not enough, the lines over restriction
become disabled.
Note 2:
This command is not available for IP PAD.
Note 3:
This command is not available for Internal PHD.
2. Parameters
Input data
MG:
Module Group Number
UNIT:
Unit Number
GROUP:
Group Information
MB:
Make-Busy Information
Make Idle: Set a circuit card to idle status
Make Busy: Set a circuit card to busy status
MB Request:
Make-Busy Request
Normal:
The registrations of idle terminals on the applicable PHL card are moved to another PHL circuit
card while the busy terminals remain on the existing PHL card until they become idle. After the
busy terminals are released, their registrations are moved to another PHL circuit card as the idle
terminals were.
Compulsion release:
The registrations of all terminals on the applicable PHL card are compulsorily moved to another
PHL, regardless of the status.