NEC SV8500 Operation And Maintenance Manual - page 936
– 889 –
CHAPTER 7
Maintenance Commands
MEM_HDD: Data Control Between Memory and HDD
1. Functional Outline
This command is used to load the Office Data from the SV8500 Flash Card to the SV8500 Memory, back up
the Office Data from the SV8500 Memory to the SV8500 Flash Card, and verify the Office Data between the
SV8500 Memory and the SV8500 flash Card.
2. Parameters
Input Data
Direction Select: Memory to Hard Disk
Hard Disk to Memory
Verify HDD against MEM
Data Type Select: Data Memory
Name Display
Wireless Call Forwarding (JAPAN only)
Call Forwarding
Speed Calling
User Assign Key
Number Sharing
ACD Data Memory
Call Block
ICB and DR
Expanded Speed Calling
Call Forwarding-Logout
One Touch Speed Calling for DtermIP
SPD Name Data
H.323 Terminal Call Transfer (Not used)
Message Area ID Data
SR-MGC Data
SIP Terminal Call Transfer
Mobility Access Data
Day/Night Data
Local Phone book Data
Soft Switch Data
LP Select:
Designate the LP number. (Required when Call Forwarding, Speed Calling, User As-
sign Key, Number Sharing, Call Block, ICB and DR, Expanded Speed Calling, Call
Forwarding-Logout, or Mobility Access Data is selected in the Data Type Select param-
eter.)
All Select:
Check this box when selecting all the data types listed in the Data Type Select field.
When individually selecting only a specific number of the data types, leave the box un-
checked (and specify the TYPEs in the Data Type Select field).
Auto Verify Afterward:Check this box to verify the data automatically after backup or restore.