NEC SV8500 Operation And Maintenance Manual - page 689
– 642 –
CHAPTER 5
Operation Procedure for System with PIR
4.8 Control System Fault - STBY Side Is Faulty
•CPU Controlling Block Diagram: See Figure 5-17, Figure 5-18 in this chapter.
Faulty Situation:
•
Fault has occurred at the STBY side of Dual Configuration system.
•
[
] STBY CPU Failure.
•
The ACT side has become faulty, and system changeover has been executed.
•
[
] Processor Failure (ACT side)
1-IMG
Replace STBY-side related circuit card
(CPU, GT, TSW, MUX, EMA) with a
spare, and check.
Replace the circuit card (CPU, GT, TSW, MUX,
EMA) individually by referring to the following:
•
CPU Card Replacement Procedure
•
EMA Card Replacement Procedure
•
•
•
(Time Division Switch) Circuit
•
Place the circuit card (CPU, GT, TSW, MUX) to
ACT mode by executing CPU or TSW change-
over. (Refer to SYSTEM CONTROL
Check to see if a station-to-station connection can
be set up to identify the circuit card
responsible for the fault.
When a fault is not indicated, set
the faulty systems to STB
Y side.
in Chapter 2.
ATTENTION
Contents
Static Sensitive
Handling
Precautions Required
START
END