NEC SV8500 Operation And Maintenance Manual - page 800
– 753 –
CHAPTER 7
Maintenance Commands
Control: Status of Control Channel
ST-B1: Status of Speech Channel (ST-B1)
ST-B2: Status of Speech Channel (ST-B2)
ST-B3: Status of Speech Channel (ST-B3)
PH LENS: Accommodation of PH
Buttons
Get:
Retrieve the information.
Exit:
Exit this command.
Execute:
Execute the reset transaction.
SIP Server ID: ID of SP [1-127]
ACT Server ID: Server condition is operated in Active-mode
STBY Server ID: Server condition is operated in Stand-by mode
WAIT Server ID: Server condition is operated in changing
OFF Server ID: Server condition is operated in suspending
Buttons
Get:
Retrieve the information.
Exit:
Exit this command.
Reset:
Reset specified SP in SIP Server ID.
Note 1:
Only when the SP is in Active mode or Standby mode, reset will be executed, if in other conditions, reset
will not be executed.
Note 2:
On Single SP, reset can be executed.
Note 3:
When reset transaction is executing, the remaining time until Time-out is displayed, if reset transaction
is not completed within 3 minutes, the task will be stopped with displaying “Time-out”.
SP mode change:
Execute forcible system changeover between Active-side SP and Standby-side
SP.