NEC SV8500 Operation And Maintenance Manual - page 719

– 672 –

CHAPTER 5

Operation Procedure for System with PIR

5.6.2

SV8500 Server Power ON/OFF Procedure

[AC-Powered Model of SV8500 Server]

Turn ON:

STEP 1: Connect an AC power code to AC inlet on Power module (on the rear panel of

SV8500 server module).

STEP 2: Turn on the PWR switch (to left) (

Note 1

). PWR lamp (on the left of Power switch) lights green.

Turn OFF:

STEP 1: On PCPro Tools menu [System Control], select [System Shutdown] and click the Execute button.

SV8500 server stops operating here. 

Note 2

STEP 2: Turn off the Power switch (to right) on the Power module.

STEP 3: Disconnect the AC power code.

[DC-Powered Model of SV8500 Server]

Turn ON:

STEP 1: Supply the power to BASEU. When the power cable between BASEU and SV8500 server is connect-

ed, BASEU starts supplying the power to SV8500 server here.

STEP 2: Turn on the Power switch (to left) on the Power module (on the rear panel of SV8500 server module)

(

Note 1

). PWR lamp (on the left of Power switch) lights green.

Turn OFF:

STEP 1: On PCPro Tools menu [System Control], select [System Shutdown] and click the Execute button.

SV8500 server stops operating here. 

Note 2

STEP 2: Turn off the Power switch (to right) on the Power module.

STEP 3: Stop supplying the power to BASEU.

Note 1:

When you want to turn on SV8500 server right after turning off the powered system, wait for a while (about

10 seconds) before powering on the system again.

Note 2:

Check the PWR lamp on the front panel of CPU card turns off. When the system is dual configuration, check

the PWR lamp goes off on both #0 and #1 CPU cards.

ATTENTION

Contents

Static Sensitive

Handling

Precautions Required