NEC SV8500 Operation And Maintenance Manual - Rlst: Release Station/trunk
– 900 –
CHAPTER 7
Maintenance Commands
RLST: Release Station/Trunk
1. Functional Outline
This command is used to release a station, trunk, or virtual trunk when using PHG circuit card.
When in-progress virtual trunk is not able to recover from a fault, this command is used to disconnect the in-
progress call forcefully due to the recovery.
2. Parameters
Input data
TYPE: Type of Select (1-5)
1=Stations
2=Trunk
3=LENS
4=Connection Trunk
5=Virtual Trunk
TN: Tenant Number
STN: Station Number (maximum six digits)
RT: Route Number
TK: Trunk Number
LENS: Line Equipment Number
Connection RT: Connection Route Number (1-1023)
Connection TK: Connection Trunk Number (1-4095)
Note 1:
This option is valid when assigning 1 or 2 on CDN68: VIR by the ART command, indicating that the
WAN or MG connections are specified as virtual trunk identification data.
Note 2:
This parameter is valid only when TYPE=1.
Note 3:
This parameter is valid only when TYPE=2.
Note 4:
This parameter is valid only when TYPE=3.
Note 5:
This parameter is valid only when TYPE=4.
Output data
STATUS: Status of Station/Trunk (1-4)
0=Not Assigned
1=Idle