NEC SV8500 Operation And Maintenance Manual - page 952
– 905 –
CHAPTER 7
Maintenance Commands
SCVT: Setting / Change of Virtual Trunk Operation Data
1. Functional Outline
This command is used to initialize memory due to changing virtual trunk data of the Protocol Handler (PH)
cards. Memory initialization starts when trunk status is Idle and Bothway Make-Busy.
Note:
Virtual trunks indicated here become available only when virtual channels via PHC are used with CCIS
over IP. Virtual channels via Media Gateway is not available.
2. Parameters
Input data
RT: Route Number
INTERVAL: Interval time of scan (seconds) [0-120]
TK: Trunk Number [1-255]
Details of a color:
Not Assigned: GRAY (Status: 0)
Idle: WHITE (Status: 1)
Busy: RED (Status: 2)
Bothway Make-Busy/Not Mounted: YELLOW (Status: 3)
Initialize Success: GREEN (Result: 1)
Initialize Failure: BLUE (Result: 2)
Note
Note:
The numbers shown in brackets are used for printout data.
RESULT indicates the memory initialization result.
STATUS indicates the trunk status.
[Read]
•
Enter the route number.
•
Click the Read button.
•
Current trunk status is displayed in different colors.
[Execute]
•
Click the Execute button.
•
When the trunk is idle and Bothway Make Busy/Not Mounted, memory initial starts.