NEC SV8500 Operation And Maintenance Manual - page 761

– 714 –

CHAPTER 7

Maintenance Commands

(b)

NODE that SOFTVER is different exists.

As a result of the data readout, the different SOFTVER (ROM)s coexist in the same network. FPC of

the corresponding node is not indicated because it is impossible to determine which SOFT-

VER(ROM) is correct. While this message is displayed, “Del.” button is invalid. 

(c)

NODE to which SOFTVER can’t be read exists.(FPC: XXX)

Program version information of a node cannot be read out due to FCCS link disconnection, etc. FPC

of the corresponding node is indicated. If multiple nodes apply, the smallest FPC in the corresponding

nodes is displayed.

(d)

CPU Faction to which SOFTVER can't be read exists. (FPC: XXX)

Program version information of a node cannot be read out due to power failure of one of the CPUs

(CPU#0/CPU#1), etc. FPC of the corresponding node is indicated. If multiple nodes apply, the small-

est FPC of the corresponding nodes is indicated.

Buttons

Get:

Read out the information. This button is always operative. Note 4, Note 5

Note 4:

By pressing this button, the following output data appears.

Note 5:

If program version data has been assigned to NDM, the assigned program version is displayed in

SOFTVER (NDM) parameter and “Del.” button will be active.

If no program version data has been assigned, the earliest program version in the FCCS network is

displayed in SOFTVER (NDM) parameter and “Set” button will be active.

Set:

Set the program version data displayed in SOFTVER (NDM) parameter. Note 6

Note 6:

To change the program version data written in NDM, delete it first, and then assign the new version

data.

Del.:

Delete the program version data written in NDM.

Exit:

Exit this command. This button is always operative.

Output Data

FPC:

Fusion Point Code of each node.

CPU:

CPU (CPU#0/CPU#1) of each node. 

SOFTVER (SYSTEM): The currently enabled program version of each node (in hexadecimal). Note 8

Note 7:

When no program version data has been assigned to NDM and each node operates without the restric-

tion of the program version data, “NO Action Limit” is displayed.

When program version data has been assigned to NDM and each node operates with the restriction of

the program version data, the assigned program version data is displayed. “No Action Limit” or the

program version data is displayed only for ACT-CPU. “-----” is displayed for STBY-CPU.