NEC SV8500 Operation And Maintenance Manual - page 235
– 188 –
CHAPTER 2
Operations of SV8500 Server
When “Automatic” is not selected, the status of the PC port follows the configuration setting.
Note:
After the registration:
If the terminal which does not support this feature is instructed to disconnect its PC port by the system,
a mismatch between the CPCP command setting and the status of the PC port may occurs.
Before the registration:
If the terminal which does not support this feature is instructed to disconnect its PC port by the system,
the CPCP command setting does not take effect.
(e) To disconnect the PC port by CPCP command, “Automatic” needs to be set on the configuration set-
ting on the terminal. The table below shows the status of PC port depending on the configuration set-
ting on the terminal and office data setting on CPCP command.
Note 3:
The default is “Automatic”.
Note 4:
If the terminal with “Automatic” is connected to the system which does not support this feature, the PC
port is connected.
Note:
Not supported on the
DtermIP INASET320C/G.
(6) The following shows the service conditions only for SIP Multiple Line terminal.
(a) The data setting (CPCP command) for the terminals in logout status is also available. The set data
takes effect after the terminals log into the System.
(b) To use this feature (CPCP command control), the following configuration setting on the terminal is
required.
•
Select “Automatic” from the User Menu
o
Advanced Settings
o
PC Port Settings
o
Port Avail-
able (PC).
When “Automatic” is not selected, the status of the PC port follows the configuration setting.
Configuration Setting
on Terminal
CPCP Command Setting
Status of PC Port
Automatic
Note 3
Connection
PC port is connected.
Disconnection
PC port is disconnected.
No data setting
PC port is connected.
OFF
Connection
PC port is disconnected.
Disconnection
PC port is disconnected.
No data setting
PC port is disconnected.