NEC SV8500 Operation And Maintenance Manual - page 770
– 723 –
CHAPTER 7
Maintenance Commands
5 = UNIT
o LEVEL o GROUP
6 = UNIT
o GROUP o LEVEL
Note 1:
In this parameter, specify the size of increment between the consecutive trunk numbers assigned. See
the example below:
Example:
STEP=2
Note 2:
Data entry for this parameter is necessary when RT is 901 or 915.
Note 3:
TYPE parameter determines how to arrange the trunk data. See Details on Trunk Arrangement TYPE
for details.
Buttons
Execute:
Make the input data valid.
Cancel:
Cancel the input data.
Exit:
Exit this command.
Output Data
TK:
Assigned Trunk Number
LENS:
Line Equipment Number
STATUS:
Data Entry Result
OK=Data Assignment is successful
Note 4:
If OK is not displayed (i.e. the data entry is not successful), related error message is displayed here.
INPUT DATA
RESULT
TK(START)=1
A Trunk Number is assigned by increments of 2
or
A Trunk Number is deleted by increments of 2
TK(END)=21
STEP=2