NEC SV8500 Operation And Maintenance Manual - page 870
– 823 –
CHAPTER 7
Maintenance Commands
DPKG: Display of Setting Port Package
1. Functional Outline
This command is used to display the circuit card name accommodated in each Group of a specific UNIT.
Note:
When using this command, make sure that each circuit card’s related database file has already been in-
stalled to the PCPro. (See the FLINST command for more information.)
Note:
DPKG command should be run during low traffic only.
2. Parameters
Input Data
MG:
Module Group Number [00-07]
UNIT:
Unit Number [0-3]
Buttons
Get:
Get information on mounted circuit cards.
Close:
Exit this command.
Note:
When the Input Data above is entered and the Get button is pressed, the related circuit card name is dis-
played on a Group basis. However, if the name is not found for some reason, the following mark may
appear in the relevant display field.
•
#
o Unidentifiable firmware type.
•
##
o Data not found in FMID (database).
•
###
o Group data not assigned.
•
*
o Circuit card name not found (for the card is in make-busy state, etc.).