NEC SV8500 Operation And Maintenance Manual - Cmwl_T:
– 750 –
CHAPTER 7
Maintenance Commands
CMWL_T:
Control Message Waiting Lamps – Telephone Number
1. Functional Outline
This command is used to control/display the Message Waiting Lamp’s ON/OFF status, by using Telephone
numbers. When the station is a Dterm, this command can also be used to control the Message Waiting Lamp
Display. This command is only available at NCN (for FCCS network).
2. Parameters
Input Data
TYPE:
Designation by Telephone Number/Designation by LEN
UGN:
User Group Number
TELN:
Telephone Number (maximum 16 digits)
LENS:
Line Equipment Number
MWLAMP:
MW Lamp Status OFF/ON
MCI:
Message Center MW Status OFF/ON
ATT:
Attendant Console MW Status OFF/ON
STA:
Station MW Status OFF/ON
VMM:
Voice Mail Module MW Status OFF/ON
Note 1:
This parameter is valid when TYPE =1 is selected.
Note 2:
This parameter is valid when TYPE =2 is selected.
Output Data
FPC:
Fusion Point Code (1-253)
TN:
Tenant Number
STN:
Physical Station Number
(a maximum of five digits for a Business system, and six digits for a Hotel system)
Note 3:
These parameters are for display only.
Buttons
Get:
Get information on the MW status.