NEC SV8500 Operation And Maintenance Manual - page 814
– 767 –
CHAPTER 7
Maintenance Commands
CSCL: Continuous Change of Station Class
1. Functional Outline
This command can change the station class information (TEC, RSC, SFC) for a group of stations by specifying
the range of the station number.
2. Parameters
Input Data
TN:
Tenant Number
STN(START):
First Station Number [0-9, #, * (maximum six digits)]
STN(END):
Last Station Number [0-9, #, * (maximum six digits)]
TEC(OLD):
Telephone Equipment Class before change [1-31]
TEC(NEW):
Telephone Equipment Class after change [1-31]
RSC(OLD):
Route Restriction Class before change [0-15]
RSC(NEW):
Route Restriction Class after change [0-15]
SFC(OLD):
Service Feature Class before change [0-15]
SFC(NEW):
Service Feature Class after change [0-15]
Note 1:
In the bottom part of the display, a check box is provided to determine whether to use “*” and “#” as
a part of the station number. If necessary, check the box.
Note 2:
Details on Telephone Equipment Class (TEC) are shown below:
1=DP (10pps)
2=PB
3=DP/PB
4=DP (20pps)
5-11=Not used
12=Dterm
13=Data Terminal via Dterm
14=Hot Line
15=CAS line
16=Data Terminal via Data Module
17=Not used
18=Virtual Line Appearance (for Dterm Multi-Line)
19-22=Not used
23=ISDN Terminal
24-26=Not used
27=8 Conference Equipment