NEC SV8500 Operation And Maintenance Manual - page 956
of
975
– 909 –
CHAPTER 7
Maintenance Commands
SPTS: Scanning of Port Status
1. Functional Outline
This command is used to display momentarily the working status of Port Microprocessor (PM) on Module
Group (MG), Unit, and Group basis.
2. Parameters
Input data
MG: Module Group Number
Unit: Unit Number
Group: Group Information
Interval: Unit for this parameter is in seconds.
Entry Procedure
Type 1: By MG
Display of Scanning by Designating MG (Figure 7-7)
Package Status
PM: Not Mounted
ID: Idle at least one
BY: All Busy
MB: Under Make-Busy Status
Note:
This information appears when the circuit card is in Make-Busy status (MB key is set upward) or when
the designated location has no circuit card.