NEC SV8500 Operation And Maintenance Manual - page 631
of
975
– 584 –
CHAPTER 5
Operation Procedure for System with PIR
STEP 7: Pull the FAN tray toward you as shown below.
STEP 8: Unfasten the FAN cables from the cable support.
STEP 9: Replace the FAN to be replaced.
•
Disconnect FAN0, FAN1, or FAN2 connector.
•
Remove the old FAN.
•
Attach a new FAN. Note
•
Connect the FAN cable.
Note:
Take into account the FAN cable connected location when attaching the FAN. Otherwise, the cable length
may not be enough to reach the FAN connector.
FAN tray
PZ-M699
FANU
FAN0
FAN1
FAN2
FAN PWR SW
ON
FUSE
MADE IN JAPAN
xxxx xxxx xx
new FAN
old FAN
(FAN0)
FAN1
FAN2
FAN cable
FAN0 connector
FAN1 connector
FAN2 connector
Cable support
FAN cable connected location