NEC SV8500 Operation And Maintenance Manual - page 766
– 719 –
CHAPTER 7
Maintenance Commands
When DELETE is selected in the TYPE selection list box
Input Data
TN(START):
First Tenant Number
TN(END):
Last Tenant Number
STN(START):
First Station Number [maximum six digits]
STN(END):
Last Station Number [maximum six digits]
STEP:
Station Count-up Step
If using asterisk (*) and number (#)
o [1-12]
If not using asterisk (*) and number (#)
o [1-10]
Note 1:
In this parameter, specify the size of increment between the consecutive station numbers deleted. See
the example below:
Example:
Buttons
Execute:
Delete the input data.
Cancel:
Cancel the deletion.
Exit:
Exit this command.
Output Data
TN:
Tenant Number
STN:
Station Number
STATUS:
Result of Deletion
Note 2:
When the deletion is successful, OK is displayed. Otherwise (i.e. the deletion is rejected), related error
message is displayed.
INPUT
RESULT
STN(START)=100
Station Number is deleted by increments of 10:
When asterisk (*) and number (#) are not used as part of STN
100
110
120
130
...
190
200
When * and # are used as part of STN
10*
118
126
134
...
1**
1#8
STN(END)=200
STEP=10