NEC SV8500 Operation And Maintenance Manual - page 926
of
975
– 879 –
CHAPTER 7
Maintenance Commands
MBPM: Make-Busy of Port Microprocessor
1. Functional Outline
This command is used to set and reset the make-busy state of the circuit card that contains the port
microprocessor. This setting and resetting is performed individually for each circuit card. If the location of the
circuit card containing the port microprocessor is specified in this command, the operating state of all circuit
cards in the associated unit is displayed.
2. Parameters
Input data
MG:
Module Group Number
Unit:
Unit Number
Group:
Group Information
MB:
Make-Busy Information
Output data
MB:
Make-Busy Information [0-1]
0=Make Idle
1=Make Busy
Note:
Idle/Busy status can be displayed and assigned by the MB parameter.