NEC SV8500 Operation And Maintenance Manual - page 535
– 488 –
CHAPTER 3
System Messages
•
Factors for outputting system message
System message that disturbs WLAN Handset/Standard SIP terminal operation is indicated as follows.
Factors for outputting system message
System Message
Outputting factors/Countermeasure
FNC=01H (Service Stop.)
Note:
Output only when
SIP Wireless Terminal
Backup is executed.
(Normal outputting factor)
•
When single SP is powered off.
(Abnormal outputting factor)
•
When single SP process is stopped or when
hardware failure occurred.
(Countermeasure for abnormal outputting)
•
Check the network equipment, connection
and configuration.
•
If failure occurs continuously despite the net-
work is normal, contact with field support.
FNC=02H (ACT Change.)
Note:
Output only when
SIP Wireless Terminal
Backup is executed.
(Normal outputting factor)
•
When changeover is executed from PCPro.
•
When active SP is powered off or rebooted.
(Abnormal outputting factor)
•
When changeover is executed by network
failure.
•
When active SP process is stopped or when
hardware failure occurred.
(Countermeasure for abnormal outputting)
•
Check the network equipment, connection
and configuration.
•
If an failure occurs continuously despite the
network is normal, contact with field support.