NEC SV8500 Operation And Maintenance Manual - page 791
– 744 –
CHAPTER 7
Maintenance Commands
White = No copy request
Yellow = On standby (already requested to copy)
Blue = Under copying
Green = Succeeded in copying
Red = Failed to copy
Magenta = Backup MGC is ready with Location Diversity.
Note 2:
When the Clear button is clicked, all the SR-MGC Numbers return to the state of No Copy Request.
Note 3:
The following kinds of office data is copied from SV8500 MGC to SR-MGC:
-DM (Data Memory)
-LDM (Local Data Memory)
-NDM (Network Data Memory)
-CF (Call Forwarding Data)
-SPD (Speed Dialing Data)
-RCF (Wireless Call Forwarding Data)
-ND (Name Display Data)
-ACD DM (ACD Data Memory)
-GPLP (Application Data Memory managed by LP)
-GPSP (Application Data Memory managed by SP)
-GPCM (Application Data Memory managed by CM)
* When accommodating SR300 to the MGC, the office data cannot be copied from the MGC to SR-MGC.
In this case, you have to assign the MGC office data to SR-MGC by your self.
Note 4:
When the Break button is pressed during office data copy, the operation is cut off after the currently
copying file is completely copied. However, when DM/LDM/NDM copy is executed, the operation is
cut off after all the DM/LDM/NDM files are copied.
File copy operation takes about two minutes per file. (The time varies depending on the connection sta-
tus of the network.)
Output Data
SR-MGC No.: SR-MGC Number [0-255]
STS: State of SR-MGC:
State of SR-MGC is indicated as follows:
OK:
Connection between SV8500 MGC and SR-MGC has been established normally
(SR-MGC is in stand-by mode)
??:
While reading the state of SR-MGC
NG:
SR-MGC power OFF, or communication error between SV8500 MGC and SR-MGC
Connect CNT: A total number of Terminals:
A total number of IP terminals and the channels for network equipments such as IP-BSs and MGs under
the registration of the SR-MGC.