NEC SV8500 Operation And Maintenance Manual - page 946
– 899 –
CHAPTER 7
Maintenance Commands
RLMG: Release of Media Gateway
1. Functional Outline
This command is used to check which channel of MG(PRI) is retaining an ongoing call (Initial setting is
incomplete). Also, the channel retaining an ongoing call can be reset (Forceful Switchover).
2. Precautions
(a) Only the channel retaining an ongoing call can be switched over forcefully by this command. For other
channels, use RLST command.
(b) This command supports the following MG(PRI).
•
MG(PRI) (1.5M) [SCA-24PRIA/MG-24PRIA] (SP-3884 MG PRI PROG-A Issue 10 or later)
•
MG(PRI) (2M) [SCA-30PRIA/MG-30PRIA] (SP-3884 MG PRI PROG-A Issue 10 or later)
3. Parameters
Input data
LENS: Line Equipment Number
Enter the LENS (six digits) assigned by AMGIL command to read out the information of MG(PRI).
Channel Number to reset: Channel Number (0-31)
Enter the channel number to switch over forcefully.
Note:
Each channel data is displayed as follows.
Display
Meaning
Gray
Not registered
Yellow
Initial setting is complete.
Red
Initial setting is incomplete.