NEC SV8500 Operation And Maintenance Manual - page 823
– 776 –
CHAPTER 7
Maintenance Commands
CSTN: Continuous Change of Station Number
1. Functional Outline
This command can change the consecutive station numbers for a group of stations by specifying the station
number range.
2. Parameters
Input Data
TN: Tenant Number
OLD STN(START): First Station Number before change [0-9, #, * (maximum six digits)]
OLD STN(END): Last Station Number before change [0-9, #, * (maximum six digits)]
NEW STN(START): First Station Number after change [0-9, #, * (maximum six digits)]
NEW STN(END): Last Station Number after change [0-9, #, * (maximum six digits)]
Note:
In the bottom part of the display, a check box is provided to determine whether to use “*” and “#” as a
part of the station number. If necessary, check the box.
Buttons
Execute: Make the input data valid.
Cancel: Cancel the input data.
Exit: Exit this command.
Output Data
OLD STN:
Station Number before change
NEW STN:
Station Number after change
STATUS:
Data Entry Result
OK=Data Assignment is successful
Note:
If not OK (i.e. the data entry is not successful), related error message is displayed here.