NEC SV8500 Operation And Maintenance Manual - page 749
– 702 –
CHAPTER 7
Maintenance Commands
ATDL: Assignment of Terminal for Download
1. General
This command assigns the data for downloading the new firmware to IP terminals.
Note:
Only the IP terminals that have established registration to the MGC can download the new firmware.
Note:
Be sure to upload the required new firmware files to the FTP server using ADTM command before ex-
ecuting the download procedure by this command.
Note:
Because a terminal can download only one firmware file, it is required to create a list file of stored firm-
ware for each type of IP terminal even if multiple versions/types of firmware are to be downloaded.
2. Parameters
Select one of the radio buttons to specify the FTP server from where the new firmware is to be downloaded for
the IP terminals.
•
ACT CPU (to specify the ACT side of Node as FTP server)
•
STBY CPU (to specify the STBY side of Node as FTP server in dual configuration)
•
External Server (to specify the FTP server connected to LAN)
IP Address:
When External Server is selected, assign the IP Address of FTP server connected to LAN (Example:
192.168.1.1).
Login Name/Password [Maximum 15 digits]:
Enter the Login Name and Password required to login to the FTP server.
Click either of the radio buttons to select the download method.
•
Sequential
(Automatically set to Sequential when ACT CPU or STBY CPU is selected. When firmware download
to one terminal has been completed, download to the next sequentially numbered terminal starts im-
mediately.)
•
Parallel
(Used when External Server is selected. Firmware download is executed on eight terminals at a time
every four seconds.)