NEC SV8500 Operation And Maintenance Manual - Sinz:
– 906 –
CHAPTER 7
Maintenance Commands
SINZ:
System Initialize
1. Functional Outline
This command is used to initialize the system from PCPro.
WARNING:
Do not use this command when the system is in normal operation since this command ex-
ecutes the system initialization.
Note:
When the system is initialized, PCPro is disconnected. After initialization is complete, log back into
PCPro.
2. Parameters
System Initialize
The system initialize is executed for ACT side with the current office data of MEM without loading
from the CF card.
Office Data Load & System Initialize
The system initialize is executed for ACT side by loading the office data from the CF card to MEM.
Program & Office Data Load & System Initialize
The system initialize is executed for ACT side by loading the program and the office data from the CF
card to MEM.
Calling keep restore
The system initialize is executed for ACT side while maintaining a call in progress.
Restart
The system initialize is executed for ACT side by restarting the system.
Shutdown
The system initialize is executed for ACT side by shutting the system down.
The system initialize is executed for STBY side with the current office data of MEM without loading
from the CF card.
The system initialize is executed for STBY side by loading the office data from the CF card to MEM.