NEC SV8500 Operation And Maintenance Manual - page 742
of
975
– 695 –
CHAPTER 7
Maintenance Commands
ALLC: Assignment of Line Load Control
1. Functional Outline
This command is used to specify the start and stop of Line Load Control.
2. Parameters
Input Data
ALL/ONE:
Operation Mode Selection (1,2)
A=All LPs
A is not valid for 1-IMG-system.
O=Only One LP
LP:
Local Partition (LP) Number
Note:
This parameter appears when O (only one LP) is set in ALL/ONE input data.
The data is designated as 00 for a 1-IMG-system.
STATUS:
Line Load Control Status (0-3)
0=Stop Line Load Control
1=Start Line Load Control
2=Automatic Line Load Control is in effect (display only)
3=Status of all LPs do not match (display only)